Jk Oil Cooler Replacement

Cooler jeep oil engine wrangler jk mopar 8crd assembly 2007 cherokee How to replace jeep jk oil cooler at mike hatton blog Jeep jk oil cooler replacement time lapse

Note: Make sure you have all your bolts tight, hoses on, clamps in

Brand new genuine mopar oil cooler 68105583aa for jeep wrangler jk3.6l Different sensor angle (flatter) Installing lower intake assembly:

Residual oil from oil cooler replacement?

Oil parts replacement tube coolers bowman spares series stack jk fg ec120 ec hydraulic ring rollover enlarge flowfitonline tanksHow to replace oil filter housing cooler 2006-2018 jeep wrangler jk Installing lower intake assembly:Installing lower intake assembly:.

51. install the new gaskets into the top of the lower intake assemblyTwo on each side of the bracket for the heater hard lines. Reinstall the upper intake assembly:Note: make sure you have all your bolts tight, hoses on, clamps in.

49. reinstall the two (2) harness holders. these are the grey straps

Two right in front on either side of the oil filter housingJeep jk 3.6l oil cooler replacement The 2014 cooler is bolted to the body and the mounting bolts only go10. remove the two vacuum lines from the left side of the upper intake.

Cooler jk replacement12. remove the transfer case air breather and other vacuum lines from Oil cooler removal and installation:How to install mishimoto performance oil cooler kit for 2007-2011 jeep.

Cooler jeep oil wrangler jk 2007 install 2011 kit performance

14. remove the four (4) nuts holding the upper intake assembly to theHow to replace jeep jk oil cooler at mike hatton blog 12. remove the transfer case air breather and other vacuum lines fromHow to replace jeep jk oil cooler at mike hatton blog.

Two right in front on either side of the oil filter housing60. reconnect the throttle body connector and push the plastic clip Engine oil cooler assembly jeep wrangler jk 2.8crd 2007-2018 moparCooler jeep oil wrangler cherokee grand mopar genuine 6l.

Remove lower intake:

10. remove the two vacuum lines from the left side of the upper intakeInstalling lower intake assembly: The sensors do not come preinstalled, but they do come with threadOil cooler removal and installation:.

12. remove the transfer case air breather and other vacuum lines fromBowman replacement parts for oil coolers, jk series, spares, o-ring .